# Trying port address 0203
# Board 1 has serial identifier 2a 00 00 00 00 33 01 93 15
# Board 2 has serial identifier e5 ff ff ff ff 70 00 8c 0e

# (DEBUG)
(READPORT 0x0203)
(ISOLATE)
(IDENTIFY *)

# Card 1: (serial identifier 2a 00 00 00 00 33 01 93 15)
# ELS0133 Serial No 0 [checksum 2a]
# Version 1.0, Vendor version 0.0
# ANSI string -->ELSA QuickStep 1000<--
#
# Logical device id ELS0133
#
# Edit the entries below to uncomment out the configuration required.
# Note that only the first value of any range is given, this may be changed if required
# Don't forget to uncomment the activate (ACT Y) when happy

(CONFIGURE ELS0133/0 (LD 0

# Multiple choice time, choose one only !

#     Start dependent functions: priority acceptable
#       Logical device decodes 10 bit IO address lines
#             Minimum IO base address 0x0160
#             Maximum IO base address 0x0360
#             IO base alignment 8 bytes
#             Number of IO addresses required: 8
(IO 0 (BASE 0x0160))
#       IRQ 3, 4, 5, 7, 10, 11, 12 or 15.
#             High true, edge sensitive interrupt (by default)
(INT 0 (IRQ 10 (MODE +E)))

#     End dependent functions
(ACT Y)))
# End tag... Checksum 0x00 (OK)